ULINE Pipe Clothing Rack Single Rail Installation Guide

ULINE Pipe Clothing Rack Single Rail

TOOLS INCLUDED

PARTS

Caster x 4	Adjustable Connector x 2	Set Screw x 2
Locking Washer x 4	Flat Washer x 4	Top Upright x 2
Bottom Upright x 2	Hangbar x 1	Base x 1

ASSEMBLY

1. Screw the four casters with flat washers and locking washers into the base using provided wrench. (See Figure 1)
2. Thread each bottom upright into the base. (See Figure 2) To fully secure uprights, place included wrench into pipe slots and tighten fully. (See Figure 2a)NOTE: Ends with slots should be facing up.
3. Screw an adjustable connector to the top of each bottom upright. Make sure connectors are facing out. (See Figure 3)
4. Tighten set screws using Allen wrench to lock adjustable connectors in place. (See Figure 4)
5. Twist each top upright into hangbar. (See Figure 5)NOTE: Ends with slots should be facing down.
6. Loosen adjustable connectors and insert hangbar with top uprights from step 5. Drop to desired height and lock into position by retightening connectors. (See Figure 6)

1-800-295-5510www.uline.com