Uline S-20903, S-20904, S-20905 Ace Elastic Bandage Instruction Manual

Uline S-20903, S-20904, S-20905 Ace Elastic Bandage Instruction Manual

INSTRUCTIONS

IMPORTANT!

Before using, you must re-roll the bandage to ensure the fastener is in the proper place for wrapping.

PREPARATION

1. Disconnect the hook closure from (See Figure 1)
2. Hold bandage so ACE™ label is facing away from (See Figure 2)
3. Hold bandage so ACE™ label is facing away from (See Figure 2)
4. Hold bandage so ACE™ label is facing away from (See Figure 2)

FOOT/ANKLE

1. Start wrapping at ball of foot, continuing under foot from inside to (See Figure 5)
2. Make two or three turns around foot, moving towards ankle with each Overlap one-half of the previous layer. Begin a figure-eight turn bringing bandage up outside of foot, over instep and inside around ankle. (See Figure 6)
3. Continue down inside of foot around heel, back up over instep, down under foot, and back up completely around ankle. (See Figure 7
4. Repeat figure-eight two or three times, overlapping one-half of the previous layer and rising above the ankle. (See Figure 8 )

CARE

1. Rinse the bandage in lukewarm soapy water by Please note, the antimicrobial treatment lasts for at least 10 washings. To prolong the life of the bandage, do not scrub the bandage.
2. Dry the bandage by laying it out flat on a clean After the bandage has dried, roll the bandage as you would after using it. Be sure to smooth out all wrinkles. This is essential for re-bandaging. No ironing is required.

Read More About This Manual & Download PDF: