H-1596TORK® XPRESS® WALL-MOUNTFULL-SIZE TOWEL DISPENSER
1-800-295-5510uline.com
TOOLS NEEDED
PARTS LIST
USING THE KEY
- To open the dispenser while keeping it locked, insert key at position A. (See Figure 1)
- Turn and hold the key clockwise to open the dispenser. (See Figure 2)NOTE: Release key back to position A after closing to lock the dispenser.
USING PUSH BUTTON MODE
- Insert key at position A. (See Figure 1)
- Turn counterclockwise to position B. (See Figure 3)
- Remove the key and push in the lock to open the dispenser. (See Figure 4)
MOUNTING INSTRUCTIONS
- Tape mounting template to wall at the desired height and ensure that template is level. (See Figure 5)
- Using a 6mm drill bit, drill into the wall about 1½” at each marked screw location on the template. (See Figure 6)
- Remove the template from the wall. Insert wall anchors (if necessary) into four previously drilled holes. Hold dispenser up to the wall so holes in wall and dispenser match up. Insert screws into the circular base of the top two holes but do not tighten completely. (See Figure 7)
- Drop dispenser down so screws slide up into narrow slots and tighten screws completely. (See Figure 8).
- Ensure the dispenser is level by looking at the level bar on the inside of the dispenser. If level, screw in the last two screws into the bottom two holes. (See Figure 9
LOADING INSTRUCTIONS
- Open the cover by using either the key or push button.
- Remove wrap from a bundle of towels. Load dispenser being careful not to overload.
- Close the dispenser and pull the first towel to begin dispensing. (See Figure 10)
0721 IH-1596
[xyz-ips snippet=”download-snippet”]