V-TAC Led Concrete Wall Lamp Rd-Light Grey Installation Guide

V-TAC Led Concrete Wall Lamp Rd-Light Grey

TECHNICAL DATA:

INTRODUCTION & WARRANTY

Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installion and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.

WARNING!

1. Please make sure to turn off the power before starting the installation.
2. Proper grounding should be ensured throughout the installation.
3. Installation must be performed by a qualified electrician.

INSTALLATION DIAGRAM

Step 1: Switch off the power before starting the installation.Step 2: Release the base plate by unscrewing the screws (Ref 5). Drill holes on the wall by using the base plate as a guide (Ref 1).Step 3: Wire and connect the power cable to the terminal block. (Ref 2). Fix the base plate to the wall using the plugs and screws(included) (Ref 3).Step 4: Install the lamp(G9) into the lamp holder (Ref 4).Step 5: Mount the fitting on the base plate using the screws. Make sure the screws are properly fixed.Step 6: Switch on the power to test the light.

In case of any query/issue with the product, please reach out to us at: [email protected] For more products range, inquiry please contact our distributor or nearest dealers. V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B

References

• 
  tac.eu