VIKING PA-IP SIP Multicast Paging Adapter with Amplifier
Out-of-Box
Verify that you have received all of the parts listed
Download the product manual
Scan the QR code to open and download the product manual
– OR –
- Go to www.vikingelectronics.com and enter PA-IP in the search box
- Click PA-IP in the search results
- Click Product Manual to open and download the PDF
Download and install the programming software
- Go to www.vikingelectronics.com and enter PA-IP in the search box
- Click PA-IP in the search results
- Scroll down the page to Downloads, click IP Programming Software
- Install the programming software by saving or opening the file and then clicking on setup Viking IP Programming.exe
- Follow the prompts on your screen to complete software installation
Power Source
Select PoE Switch or PoE Injector that meets the following requirements:
- IEEE 802.3af / 802.3at / 802.3bt compliant
- Capable of providing at least 13 Watts (class 0 or class 3)
Note: CAT5e (or higher) cable recommended
Network Port Settings
- Make sure the port is not in trunk mode
- Make sure port is capable of 100mbps full duplex
- Disable Spanning Tree Protocol (STP) or enable Port fast
Features Overview
See the Product Manual for complete installation and programming instructions. Questions?Call Viking Product Support: 715-386-8666
| Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes. |
References
[xyz-ips snippet=”download-snippet”]