VONN VAW1192 LIGHTING Tall LED Wall Sconce
TOOLS YOU MAY NEED
|
|
|
|
|
|
|
|
GOGGLES
TAPE MEASURE
RUBBER GLOVES
PHILLIPS SCREW DRIVER
DRILL
LADDERPARTS LIST
|
|
|
|
|
|
|
Mounting Bracket x 1
Outlet Screws x 3
Wire Connectors x 3
Ground Screw x 1
Canopy Screws x 2CIRCUIT BOX
LED INFO & WARNINGS 
| Please read and understand the entire manual before attempting to assemble, operate, or install the product. | Make sure that you have all necessary parts by checking the parts list. If any part is missing or damaged please contact VONN LIGHITNG CUSTOMER SERVICE at 888-604-8666 for a replacement. |
| All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn or broken. | Inspect the LED fixture prior to installation to make sure that it has not been damaged during shipping. |
| Please handle the LED light with care when unpacking. Do not apply pressure to the LED’s, do not open any factory sealed compartments, and do not touch the LEDs with your hands. | VONN highly recommends to use a qualified, licensed electrician to install the fixture.  |
| VONN recommends to install the fixture on its own independent circuit. Do not install the fixture on the same circuit with the other appliances, or HVAC systems. | Do not remove or replace VONN manufactured parts that is provided with the fixture. |
| Place the wall switch in the “OFF” position of the room you are installing the fixture.Shut “OFF” the electricity at main fuse box. | VONN recommends ELV (Electric Low Voltage) type dimmers for this fixture. |
Fixture Diagram
Step 1. Install Mounting Bracket
Attach mounting bracket (A) to outlet box with outlet screws (B).
Step 2. Connect Wires
Supply Wires:Connect Black (Line Wire) from fixture to Black (Hot Wire) from outlet box.Connect White (Neutral Wire) from fixture to White (Neutral Wire) from outlet box.Ground Wires:Connect Bare Copper (Ground Wire) from fixture to Green or Bare Copper (Ground Wire) from outlet box.Twist wires together clockwise and secure with wire connector (C).
Installer Tip (1): If ground wire is not available in outlet box, then secure Bare Copper (Ground Wire) from fixture to ground screw (D) on mounting bracket (A).
Installer Tip (2): Supply wires can be either tucked into outlet box or fixture canopy.
Step 3. Mount Fixture
Step 4. Turn Power ON
Turn electricity “ON” at main fuse box.Place the recommended ELV type dimmer switch in the “ON” position to test the fixture.
References
[xyz-ips snippet=”download-snippet”]