WALI Bookshelf Speaker Wall Mounting Bracket Installation Guide

INSTALLATION MANUALSWM201XL[email protected]

This pack contains 2 speaker mounts Suitable for loads up to 25kg (55lbs) each speaker

UNPACKING INSTRUCTIONS

  • Carefully open the carton, remove contents and layout on cardboard or other protective surfaces to avoid damage.
  • Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
  • Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

Install and operate this device with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation.

Please call a qualified installation contractor for help if you:

  • If you don’t understand these directions or have any doubts about the safety of the installation.
  • If you are uncertain about the nature of your wall, consult a qualified installation contractor.

Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied Parts List

CAUTION! This Speaker mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.

Tools R equired • 3.8mm Drill Bit• Phillips Screwdriver • 8mm Masonry Bit• Carpenter’s Level

Note: The mounting components and hardware supplied in this package are not designed for installations to walls with steel studs or to cinder block walls. If the hardware you need for your installation is not included, please consult your local hardware store for proper mounting hardware for the Application.

Before You Start

Optional Speaker Wire Management

Step 1 : Mounting the Wall Bracket to the Wall

Step 2 : Attaching the Wall Bracket Cover and the Speaker Platform to Wall BracketStep 3: Placing Speaker on the Platform,  Adjust Clamps to Hold Speaker in PlaceStep 4 : OPTIONAL: Secure Speaker Using M4x12 Wood ScrewsStep 5: Adjusting the Tilting Angle and Swing the Speaker

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,