wALI Projector and Laptop Tripod Stand User Manual
WARNING!
WARNING!If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.
TIP OVER WARNING
Serious or fatal crushing injuries can occur from Tip Over. To help prevent Tip over:
- Never allow children to climb, stand, hang, or play on any part of monitor or stand.
- Use Tip Over restraint or anchors stand to wall.
- Use of Tip Over restraints may only reduce, but not eliminate risk of Tip Over.
Small Parts Not for Children under 3 Years. Adult supervision is required.
Supplied Parts List
- Folding Tripod Stand A (x1)
- Knob B (x1)
- Plate C (x2)
- Tray D (x2)
- Tray E (x1)
- Velcro Strap F (x2)
Step 1
Combine Part D and Part E as a tray.
Step 2
Attached the Plate C to the tray and secure it.
Step 3
Screw the knob B into the try manually.
Step 4
Loosen the round locking knob and rotate to make sure the jagged lines faces the little hook of the tray, then tighten the round locking knob.
Step 5
Fold out the tripod stand and adjust to your preferred height. Lock the buckles.
Step 6
Screw the tray onto the tripod stand, and double check that the jagged line is facing the middle of the tray.
Step 7
Secure the device with Velcro Strap F.
Step 8
Adjust the knob B for optimal titling angle. (-20o / + 20o)
Step 9
Removing and stowing the tray in the nylon storage bag when not in use.
References
[xyz-ips snippet=”download-snippet”]