INSTALLATION MANUALWL-TVDVD-03[email protected]
UNPACKING INSTRUCTIONS
- Carefully open the carton, remove contents, and layout on cardboard or another protective surface to avoid damage.
- Check package contents against the Supplied Parts List on the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
- Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation.Please call a qualified installation contractor for help if you:
- If you don’t understand these directions or have any doubts about the safety of the installation.
- If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly specified in this instruction.We hereby disclaim any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Supplied Parts List
 |
 |
 |
 |
 |
 |
Step 1Connecting the Support Column to Tempered Glass
Step 2Mounting column, connector, and head part
Step 3Mounting TV plate to the headstock
Step 4Mounting the Monitor Brackets to a TVFirst of all, make sure your TV mounting holes are compatible with the size and diameter of the provided Bolt (l to r). Once you have determined the correct diameter, please see the diagram below. Install the Bolt into the TV using the correct Washer(s,t,u), and using the spacer(v,w) if necessary. Please make sure the Monitor Brackets are vertically centered and level with each other.Adjust the monitor brackets to different heights according to your viewing and setup preference.
Step 5Attaching TV To TV Plate and Managing the Wires
Step 6Attaching the Security Steel Wire to the TVIf your TV is positioned close to the wall as shown in Diagram 5a, then a steel wire can be attached for added security.Attach two ends of the steel wire to the top two holes on the back of TV, shown in Diagram 5b.
Attach the other end of the steel wire to the wall according to your wall type, shown in Diagram 5c, 5d and 5e.
[xyz-ips snippet=”download-snippet”]