waterpik WP-100 Ultra Water Flosser User Guide

Table of Contents

waterpik WP-100 Ultra Water Flosser User Guide

Prepare the Reservoir

Remove the reservoir from base and fill with lukewarm water.
Replace the reservoir onto the base, PRESSING DOWN FIRMLY to ensure full seating.

Insert Tip

Press tip firmly into handle. When tip is properly inserted there should be no gap between handle and colored tip ring.

Prime Unit (First Time Use Only)

Prior to Very First Use of Unit, Prime Unit: Set pressure control dial on base to high, point the handle and tip into sink. Turn unit ON until water flows from the tip, turn unit OFF.

This device is only compatible with a voltage system of 120VAC, 60Hz.
Do not plug this device into a voltage system that is different.

Adjust Pressure and Pause Control

For first time users, adjust pressure control to lowest position. Gradually increase pressure to your liking.
You can temporarily stop water flow by pressing the pause button on the handle.

On/Off Procedure

Always place tip in mouth before turning unit on.

Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON. Always PAUSE or turn unit OFF before removing tip from mouth.

Technique Tips For Best Result

Aim the tip just above the gum line at a 90 degree angle.
Pointer Starting with the back teeth, follow the gum line and pause briefly between teeth.
Continue until all areas around and between teeth have been cleaned.