USERUNDERMOUNT RANGEHOODSM AANNUA L
LABEL HERE
IMPORTANT: Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. lease retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.
WARNING & SAFETY INFORMATION
TECHNICAL GUIDANCE
- There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.
- There is a fire risk if cleaning is not carried out in accordance with the instructions.
- Exhaust air must not be discharged into an existing flue which is used for exhausting fumes from appliances burning gas or other fuels.
- The minimum distance between the hob surface and the lowest part of the rangehood is 600mm. This distance shall be at least 650mm if the range hood is installed over a gas hob.
- If the instructions for the gas hob specify a greater distance, this has to be taken into account.
- Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. If the supply cord of this equipment is damaged, it must only be replaced y the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- This appliance has been designed for indoor domestic use only.
- CAUTION: Accessible parts may become hot when used with cooking appliances.
DO’S & DONT’S
- Do not flambe under the rangehood.
- Do not remove or inspect the filters whilst the hood is in operation.
- You must read the details concerning the method and frequency of cleaning.
SAFETY WITH CHILDREN
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been governing by supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- Young children should be supervised to ensure that they do not play with the appliance.
OPERATING INSTRUCTIONS520, 750 & 900 UNDERMOUNT RANGEHOODSFAN SPEEDLOW/OFF/HIGH switch – Located on the left-hand side of the control panel.This unit features 3-speed settings; single line indicates low speed, double lines indicate medium speed & triple lines indicate high speed.To turn the unit off, set the speed switch to the 0 positions (off).LIGHTOn/Off switch – located on the left-hand side of the control panel as indicated in the diagram above.
MAINTENANCE & TROUBLESHOOTING
GENERAL MAINTENANCEEnsure that the power to the unit is switched off prior to cleaning the unit. The surface should only be cleaned with warm soapy water and a soft non-abrasive cloth. In coastal environments and humid areas, more frequent cleaning is required to maintain the finish.
FILTERThis unit is supplied with an Aluminium filter designed for ducted installations. The Aluminium filter is dishwasher safe or can be cleaned with hot soapy water. Ensure that filter is thoroughly dry before re-installing.You may want to order Carbon filters designed to eliminate odors from the exhaust fumes when installingthe appliance for recirculating mode. This type of filter cannot be cleaned and should be replaced every 3-6 months depending on use.
LAMPSBefore replacing, ensure that the lamps are completely cool and the power to the unit has been switched off. Replacement Lamps can be purchased from customer care. Contact details on the front page.To remove the lamp, twist the lamp in an anti-clockwise direction. Be careful when installing the new lamp not to make contact with the skin as this may damage the lamp and shorten its life.
LAMP TYPE: GU10 – 3W LED (x2)
INSTALLATION & DUCTING
IMPORTANT: Before handling the rangehood during the installation, it is recommended that you remove the filter to prevent damage.
The image to the left illustrates the minimum height from the hob surface to the underside of the rangehood.Electric hob – 600mmGas hob – 650mm.
NOTICE: IF THE INSTRUCTIONS FOR THE GAS HOB SPECIFY THE GREATER DISTANCE, THIS HAS TO BE OBSERVED. ANY INSTALLATION ABOVE 750MM WILL COMPROMISE PERFORMANCE.
INSTALLATION & DUCTINGDUCTED OPTIONNOTICE: ALL DUCTING MATERIAL MUST BE COMPLIANT WITH THE LOCAL LAWS IN FORCE.
INSTALLATION
- Remove the filter and light globes. (If installed)
- Remove the stainless steel fascia (2 screws) – take care not to damage the fascia.
- Determine the most efficient path for the ductwork, minimize bends and keep the length of the ductwork to a minimum.
- It is important to run and finish (install roof/wall caps) prior to installation on the hood.
- Cut out the cabinetry as per the installation diagram. Ensure that access has been allowed for the power cable.
- Hold the hood up to the underside of the cabinet (2 people required); Screw the hood to thecabinetry.
- Attach the ducting adaptor to the ducting.
- Re-install the stainless steel fascia.
- Re-install filter.
- Plugin the power into the unit, turn it on, and test.
WARNING: Do not penetrate any screws into the rangehood as this may result in electrical hazards. Failure to install the screws or fix the device in accordance with these instructions may result in electrical hazards.
Version 1.2We are committed to ongoing research and development. Every effort has been made to ensure all information in the user manual is correct at the time of going to print. Dimensions should be used as a reference only and actual dimensions should be taken from the physical product.
[xyz-ips snippet=”download-snippet”]