X-Rocker 2.1 Bluetooth Sound Rocker Instruction Manual
Warning! Assembly Instructions X-Rocker 2.1 Bluetooth® Sound RockerIMPORTANT:RETAIN FOR FUTURE REFERENCEWarning! Chair arms are for support only.To avoid damage or injury, do not sit or stand on the arms. Do Not move, or lift chair from the arms.
WARNING
Crush Hazard Keep hands and fingers away
Step 1: Turn the chair over to install mechanism (C) .Tighten the bolts with Allen wrench (F).
Step 2: Insert tube (B) inside mechanism (C).
Step 3: Place the pedestal on the tube, then press the pedestal to tighten the tube.
Step 4: Insert pin(M) into lower threaded hole on each side of the chair. Tighten with “-” screwdriver until it’s fully inserted.
Step 5: Attach right arm to the chair using parts shown above. 1. Place the large washer (P) between the arm (D) and the chair. 2. Insert the metal sleeve (N) into the hole of the arm (D). 3. Then place the small washer (O) between metal sleeve and screw (I). Use the supplied Allen Wrench (K) to tighten the bolts. The arms should pivot freely.
Step 6: Push plastic cap (J) into hole, hiding the bolt. Repeat Steps 4 to 6 in the assembly of the left side.
Step 7: Fold open the chair and insert pin (L) into closure and apply Velcro flap. For future storage, remove pin (L) and fold in half.
[xyz-ips snippet=”download-snippet”]