BraunAbility 427358 Remote
How to set up the BraunAbility Remote app
- Download the BraunAbility Remote app from Google Play or App Store.
- Activate Bluetooth on your smart-phone.
- Press the Teach-in button (A) quickly three times in a row and follow the setup wizard in the app.
- If the Teach-in button on the receiver isn’t accessible, run the lift until it is.
Before using this device, download and read the user manual available at: www.braunability.eu
How to install the BraunAbility Remote receiver
Q-series
- Disconnect the standard hand held control and replace the standard socket with the adapter cable socket. Remove the standard cable socket by pushing out the 4 clips from the inside. Reuse the clips when fitting the adapter cable socket.
- Connect the old socket to the adapter cable inside the pump module and the hand held control on the outside.
- Connect the adapter cable to the receiver.
- Mount the receiver according to the illustration using the supplied adhesive pads and fasten using a drill (5 mm) and one plastic clip.
- Use the supplied cable tie to tidy up the excess cable.
- Switch from A to B on the main control board inside the pump module of the lift.
Vista, Millennium, Century
- Choose placement, inside, on or near the pump module. Ensure that the Teach-in button on the receiver is easy to access. Mount the receiver in step 4.
- Connect the adapter cable.A, Inside pump module: See step 1 and 2 for Q-series. B, Outside pump module: Disconnect the standard hand held control. Connect the supplied adapter cable between the pump module and the standard hand held control.
- Connect the adapter cable to the receiver.
- Mount the receiver according to the illustration using the supplied adhesive pads. In some cases it might be necessary to drill (5 mm) and use the supplied clips.
- Use the supplied cable tie to tidy up the excess cable.
References
[xyz-ips snippet=”download-snippet”]