Denver Soundbar User Manual
What’s in the Box?
Connecting Your Sound Bar to Your TV or other sources:
1a. Is an HDMI input jack on your TV labeled “ARC”?
1b. Don’t have ARC or Optical output available on your TV?
NOTE: All cables what you needed should be plugged in before Power Supplies connected.
2. Connect the Power Supplies to Sound Bar then power Insert Power Supplies to an AC outlet.
3. Turn on your sound bar.
Placing the Soundbar on a flat and solid surface. Hold the Power button /MODE at the right side of the sound bar or Press RED key on the remote control to turn it on. Selecting Mode (input source) as the following instruction to enjoy your powerful sound. When the Soundbar is switched to standby, the red dot is turned on.
NOTE:
- RESET: Hang up is solved by disconnecting and reconnected the power supplies.
- It will be standby within 10 munities if no signal from Line In, BT, USB, ARC and Optical inputs. It also will be standby if the low sound from Line In need to be heard within about 15cm distance.
The control panel on the Soundbar:
Importance Notice for soundbar mounting on the wall:
- Wall-mounted installation must be carried out by qualified personnel only. Incorrect assembly can result in severe personal injury and property damage! (If you intend to install this product yourself, you must check for installations such as electrical wiring and plumbing, which may be hidden inside or behind the wall.)
- It is the installer’s responsibility to verify and confirm that the wall will safely support the total load of the unit and wall brackets.
- Additional tools (not included) are required for the installation.
- Do not overtighten screws.
- Use an electronic stud finder to check the wall type before drilling and mounting
- The proposed height on the wall is 1.0~1.5meters
- The strain relief (<23mm) of HDMI cable is recommended for more space during mounting.
Technical Specifications
Please notice – All products are subject to change without any notice. We take reservations for errors and omissions in the manual.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S
Electric and electronic equipment and included batteries contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked with the crossed out trash can symbol, seen above. This symbol signifies that electric and electronic equipment and batteries should not be disposed of with other household waste, but should be disposed of separately.
As the end user it is important that you submit your used batteries to the appropriate and designated facility. In this manner you make sure that the batteries are recycled in accordance with legislature and will not harm the environment.
All cities have established collection points, where electric and electronic equipment and batteries can either be submitted free of charge at recycling stations and other collection sites, or be collected from the households. Additional information is available at the technical department of your city.
Hereby, Inter Sales A/S declares that the radio equipment type DSB-4020 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.denver-electronics.com and then click the search ICON on topline of website. Write model number: DSB-4020. Now enter product page, and red directive is found under downloads/other downloads.
Operating Frequency Range: 2402-2480MhzMax Output Power: 40W
DENVER ELECTRONICS A/SOmega 5A, SoeftenDK-8382 HinnerupDenmarkwww.facebook.com/denverelectronics
References
[xyz-ips snippet=”download-snippet”]