SOUNDPEATS Sonic Earbuds In-Ear Bluetooth Headphones User Manual

SOUNDPEATS Sonic Bluetooth Earbuds

USER MANUAL

Pairing

  1. The earbuds automatically pair to each other after being taken out from the charging case. The indicator of the main earbud flashes in orange and white alternately, and the indicator of the second earbud stays on white.
  2.  Activate Bluetooth on the device, and hit “SOUNDPEATS Sonic” on the Bluetooth list to pair.

Reset

  1.  Clear the pairing record on your devices.
  2. Place back both earbuds into the charging case and make sure they are in charging status.
  3. Press and hold both MFBs for 10s until both LEDs on the earbuds flash white twice, reset completely.

Wearing

Product Diagram

Button Control

Function

Operation

Power On Auto: Take out the earbuds from the charging caseManually: Press and hold the MFB for 1.5s
Power Off Auto: Place back into charging caseManually: Press and hold the MFB for 8s
Play / Pause Single tap the MFB
Volume – Double-tap the left MFB
Volume + Double-tap the right MFB
Previous Track Press and hold left MFB for 1.5s
Next Track Press and hold right MFB for 1.5s
Answer / Hang Up Phone Call Single tap the right MFB
Reject Phone Call Press and hold the MFB for 1.5s
Switch Between Two Calls Press and hold the MFB for 2s
Manually Enter Pairing Mode Press and hold the MFB for 5s
Activate Voice Assistant Triple tap MFB on the right earbud
Game Mode Triple tap MFB on the left earbud
Turn on/off the indicator Tap MFB for 4 times

Game Mode

SOUNDPEATS Sonic uses the latest technology and is equipped with game mode. In the game mode, ,earbuds delay will be greatly reduced to ensure the synchronization ofthe game audio and picture.Triple tap MFB on the left earbud to turn on/off the game mode. The earbud prompts “Game Mode” when the mode is on, and prompts “Exit Game Mode” when it’s off.

Q & A

Q1: What do the charging LEDs tell while charging the case?The LEDs stay on while charging, and turn off after fully charged.When taking out/placing back the earbuds, the indicator of the headset will light up for10s to show the current battery status of the charging case:100%—50% Shows Green49%-10% Shows YellowBelow 10% Shows Red

When charging the charging case, the indicator will flash slowly:Below 20% The indicator flashes in red slowly20%-69% The indicator flashes in yellow slowly70%-99% The indicator flashes in green slowly100% The indicator stays on greenQ2: Why are the earbuds still connected to my phone after placing them back?1. The charging case is out of battery. The case will not turn off the earbuds if the casebattery is dead.2. Please make sure the earbuds sit well in the charging case, and the chargingcontactors on both the earbuds and charging case are clean. If not, please trysomething like a microfiber cloth to clean the contactors.

Q3: The battery life is not as advertised?A single charge will not give you 45 hours of playtime constantly. The earbuds work around 15 hours per charge with average use. The charging case provides another 2recharges.

FCC Statement

This equipment hos been tested and found to comply with the limits for a Class B digital device, pursuant to Port 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful Interference in a residential installation. This equipment generates uses and con radiate radio frequency energy and. if not installed and used In accordance with the instructions. may cause harmful interference to radio communications.

However there is no guarantee that Interference will not occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to Corrects the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into on outlet on a circuit different from thot to which the receiver is connected
  • Consult the dealer or on experienced radio/TV technician for help.

This device complies with port 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.(2) this device must accept any interference received, including Interference that may cause undesired operation.

report this ad

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by