TrueAir2Using Guide
Pairing
- The earbuds automatically pair to each other after being taken out from the charging case. Light on the main earbud fiashes in white and red, the second earbud stays in white.
- Activate Bluetooth on the device, and choose “SOUNDPEATS TrueAir2” on the Bluetooth list to pair.
Reset
(Try the following steps if you fail to build a connection between two earbuds, or between earbuds and device.)
- Clear the pairing record between the earbuds and all your devices.
- Place back both earbuds and make sure they are in charging status. Press and hold both MFBs for 10 seconds until both indicators fiash in white twice.
Wearing
Product Diagram
| Power On | Auto: Take out from charging case Manually: Press and hold the MFB for 1.5s |
| Power Off | Auto: Place back into charging case Manually: Press and hold the MFB for lOs |
| Play / Pause | Double tap the MFB |
| Volume – | Single tap the left MFB |
| Volume + | Single tap the right MFB |
| Previous Track | Press and hold leff MFB for 1.5s |
| Next Track | Press and hold right MFB for 1.5s |
| Answer / Hang Up Phone Call | Double tap the touch button |
| Reject Phone Call | Press and hold the MFB for 1.5s |
| Switch Between Two Calls | Press and hold the MFB for 2s |
| Manually Enter Pairing Mode | Press and hold the MFB for 6s |
| Activate Voice Assistant | Triple tap the MFB |
Q&A
Q1: What do the charging LEDs tell while charging the case?
The LEDs stay on while charging, and turn off after fully charged.
Q2: Why are the earbuds still connected to my phone after placing them back?
- The charging case is out of battery. The case will not turn off the earbuds if the case battery is dead.
- Please make sure the earbuds sit well in the charging case, and the charging contactors on both the earbuds and charging case are clean. If not, please try something like a microfiber cloth to clean the contactors.
Q3: The battery life is not as advertised?A single charge will not give you 25 hours of playtime constantly. The earbuds work around 5 hours per charge with average use. The charging case provides another 4 recharges.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:— Reorient or relocate the receiving antenna.— Increase the separation between the equipment and receiver.— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.— Consult the dealer or an experienced radio/TV technician for help.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
MANUFACTURER
Shenzhen SoundSOUL Information Technology Company Limited
Room 1308-1309, Building B, Huaihai Square, Chuangye Road,Longhua District, Shenzhen, China. 518109
[email protected]
www.soundpeatsaudio.com
FCC ID: 2AFTU-DD012MADE IN CHINA
References
[xyz-ips snippet=”download-snippet”]