Tribit TS-BTS20 Portable Wireless Speaker User Manual
Table of Contents
Tribit TS-BTS20 Portable Wireless Speaker User Manual
Safety instructions
Avoid droppirg.
Do not disassemble.
Avoid extreme temperatures.
Do not use the device outdoors during thunderstorms.
Do not use any corrosive cleaner/Oil to dean.
Specification
Bluetooth version : Vb 0Support A2DP: AVRCP. HFP, HSPOutput power: 2 x 8W Battery: 17V, 4400mAhBattery charge time: 5 hourInput: DC5W1ADimension: 175 x 59 x 56 (mm)Weight: 380g
What’s in the box
XSound Go
USB-C Cable
Lanyard
User Manual
Overview buttons & Indicators
Connections
Bluetooth connections
Stereo Mode
Make Sure both speakers are on.
Press on one of the speakers to enter pairing states.
Press on the other speaker for 5s, then release the button to enter Stereo pairing when you hear the “Stereo Mode”.When you hear “Left chanel” on the left speakers and “Right chanel” on the right speaker , the “Stereo mode” is on.
Buttons
Button
Operation & Function
Power On/off
Press to turn on/off
Bluetooth
Press to enter pairing mode
Volume +
Press to increase the volume level
Volume –
Press to decrease the volume level
Play/Pause
Press to play/pause Music and answer/end call
Long press to reject a call
Press twice to skip to next track
Press triple to skip to Previous Track
Indicator
Indicators
Status
Blue Indicator flashes slowly
Reconnection mode
Blue indicator flashes quickly
Bluetooth pairing mode
Blue indicator keeps on
Pairing has been successful
Red indicator flashes Slowly
Low battery power (<15%) charge the speaker as required
Red Indicator flashes quickly
Low battery power (<2%) and will automatically power off after 5s charge the speaker immediately
Reset
Reset If this speaker has some problem, you can try to press and hold “Volume +” and “Volume -” button simultaneously for 5 seconds to reset, and then pairing again (delete the old pairing in your device).
FCC Statement
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF warning for Mobile device: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.